Folded bangle

This is the prototype for the folded bangle. Almost got all the design kinks are out and I'm happy with the results so far. Looking at it now, I see the possibility for a commercial piece where I use just the tubes and the rubber for a bangle or neck piece. It will be more marketable because it would not have all the sharp edges on this one and will be less hazardous.

Coffee

Finally finished, the handle now just needs to be attached. The polished outer edge should look good when you crank the handle. To add contrast I left the raw worked surface on the rest of it and darkened it by heating it. This will also go better with the rest of the coffee grinder which is made of cast iron.

Teaser

use this for teaser just crop most of it off so it does not look like jewellery

this is the forged section of the coffee grinder. I have decided to leave the forged texture on it and clean and polish the edges to give it a finished look